Description of problem: Jan 6 17:44:09 wb kernel: r8169 0000:03:00.0: eth0: unable to load firmware patch rtl_nic/rtl8168e-2.fw (-2) Version-Release number of selected component (if applicable): How reproducible: always Steps to Reproduce: 1. reboot 2. grep firmware /var/log/messages lshw snippet *-network description: Ethernet interface product: RTL8101E/RTL8102E PCI Express Fast Ethernet controller vendor: Realtek Semiconductor Co., Ltd. physical id: 0 bus info: pci@0000:03:00.0 logical name: eth0 version: 05 serial: d4:85:64:0d:ef:a4 size: 100Mbit/s capacity: 100Mbit/s width: 64 bits clock: 33MHz capabilities: pm msi pciexpress msix vpd bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation configuration: autonegotiation=on broadcast=yes driver=r8169 driverversion=2.3LK-NAPI duplex=full firmware=N/A ip=192.168.1.132 latency=0 link=yes multicast=yes port=MII speed=100Mbit/s resources: irq:42 ioport:e800(size=256) memory:febff000-febfffff memory:fdffc000-fdffffff
Hi, thanks for reporting this bug. Assigned to the package maintainer. (Please set the status to 'assigned' if you are working on it)
Keywords: (none) => TriagedAssignee: bugsquad => tmbSource RPM: (none) => kernel
Solution: install kernel-firmware-nonfree and rt3090-firmware packages.
What these package not automatically installed when you have run drakconnect ?
*** Bug 4046 has been marked as a duplicate of this bug. ***
(In reply to comment #3) > What these package not automatically installed when you have run drakconnect ? If you mean during install phase, apparently not. Can only guess it was because they are in the non-free/tainted repos :) and not on install dvd. :( Guessing all RTL8101E/RTL8102E on motherboard nic users are going to need an errata paragraph of their own. I had enabled tainted repos before doing a urpmi --downloader wget --auto --auto-update You pencil whipped bug 4046 as a duplicate. I disagree with that, all though I can see your reasoning. System bogged down because of the constant kernel attempts to get phy0 up and running and filling logs with messages every few seconds.
Trying to ping 41 bug reports in one move, because nothing has happened with them for more than 3 months, they still have the status NEW or REOPENED, there is no "OK" on the Whiteboard and severity and priority are "normal" or higher. Is this one still valid for Mageia 2 rc? If it is and you're the assignee, please set status to ASSIGNED if you think this bug was assigned correctly. If for work flow reasons you can't do that, then please put OK on the whiteboard instead. If it wasn't assigned correctly, please assign back to Bug Squad and explain.
I'll resolve this one because the system did not bog down retrying hardware setup needing nonfree/tainted firmware packages.
Status: NEW => RESOLVEDResolution: (none) => FIXED