Description of problem: WIFI USB3 Adapter not recognised after upgrading Kernel from 5.5.15 to 5.6.5 Version-Release number of selected component (if applicable): Aukey WF-R12 1750Mps Dual Band WIFI USB3 Adapter How reproducible: Attached during boot up and when in the GUI Steps to Reproduce: 1. 2. 3.
The information for the updated 5.6.5 Kernel in the hardware section of the Mageia control center reads as follows: Note: The 802.11ac NIC description for the device comes under the heading for a scanner for Kernel this new kernel. Vendor: Realtek Description: 802.11ac NIC Media class: Connection Bus: USB Bus PCI #: 5 PCI device #: 3 Vendor ID: 0x0bda Device ID: 0x8813 Misc Module: usbcore The information for the 5.5.15 Kernel in the hardware section of the Mageia control center reads as follows: endor: Realtek Description: 802.11ac NIC Media class: Connection Bus: USB Bus PCI #: 6 PCI device #: 3 Vendor ID: 0x0bda Device ID: 0x8813 Misc Module: rtl8812au I can only assume from the above that the module for this device has not been loaded correctly or is not actually in this new Kernel. Please advise.
CC: (none) => chrisv11c
Thanks for the report. You got this new kernel quickly; I only see kernel-5.5.15-3 as the latest. Assigning to the kernel people.
Assignee: bugsquad => kernel
Yuo seem to have some external driver / dkms package in your system. our module is named 8812au, with no *rtl* before.
CC: (none) => tmb
I would like to stress this Adapter was not recognised by the system prior to Kernel 5.5.9 until I raised a bug report (Bug 26178). From Kernel 5.5.9.1 to 5.5.15 it worked perfectly until I installed Kernel 5.6.5-2. I installed Mageia 7 from scratch on a different hard drive and installed all the updates up to Kernel 5.5.15. I installed the Adapter in a USB port for the first time and configured it to work. I then upgraded the Kernel to 5.6.5-2, rebooted the system to the new kernel and the Adapter was not recognised properly again. Prior to upgrading Kernel 5.6.5-2 I did check the module used in Kernel 5.5.15 in the hardware section of the control center and it gave the Module: rtl8812au that was used. This must be the one given from the fixed/resolved bug 26178 that allowed the Adapter to work up to Kernel 5.5.15. I have not installed any external driver / dkms package in the system as all the updates were accomplished through the Mageia repositories.
ok, will see where it broke...
In the upcoming kernel 5.6.6-1 I've rolled back the 8812au driver to the older revision used in 5.5.15 kernel... It's just started building for Cauldron, so the kernel for Mga 7 should be available sometimes tonight / tomorrow
This issue has been resolved
Resolution: (none) => FIXEDStatus: NEW => RESOLVED