Attempting to configure scanner in MCC with an HP Scanjet 5p SCSI on SCSI ID 3.  The scanner is not found on the system.  Adding manually still leaves it not found.

lspcidrake entry for the SCSI Card is as follows:

aic7xxx         : Adaptec|AIC-7860 [STORAGE_SCSI] (vendor:9004 device:6078) (rev: 01)

and the scanner is found by the adaptec SCSI select utility at boot.


The following is console output while trying to configure the scanner under MCC.
boinc-client.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig boinc-client --level=5
mandi.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig mandi --level=5
msec.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig msec --level=5
netconsole.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig netconsole --level=5
network-auth.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig network-auth --level=5
network-up.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig network-up --level=5
network.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig network --level=5
numlock.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig numlock --level=5
partmon.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig partmon --level=5
resolvconf.service is not a native service, redirecting to /sbin/chkconfig.
Executing /sbin/chkconfig resolvconf --level=5

Note: This output shows SysV services only and does not include native
      systemd services. SysV configuration data might be overridden by native
      systemd configuration.


Reproducible: 

Steps to Reproduce: